May 23, 2012<\/p>\n
I often am asked to describe the differences between 1MTD and MYN. Most of you by now know that MYN is a more robust (and more complex) tasks system that handles higher volumes of tasks compared to the simpler 1MTD system. It does this primarily through its use of the start date field\u2014using that adds a great amount of power. And use of that start date is the main technical<\/em> difference in implementing MYN. For a list of more differences, see this page<\/a>.<\/p>\n However I\u2019d like to mention a less obvious (but still important) difference between 1MTD and MYN that I only cover in my longer classes, and that\u2019s this: they each use the Over-the-Horizon (low-priority) zone a bit differently. This is subtle; but if you want to dig deeper into these systems, read on.<\/p>\n 1MTD\u2019s Use of the Over-the-Horizon Urgency Zone <\/strong><\/p>\n Let\u2019s start with more introductory 1MTD system. In 1MTD, the Over-the-Horizon section (the bottom or low priority section) is defined purely as this: it\u2019s a place to park all tasks that can wait later than 10 days. That\u2019s it\u2014very simple. So in 1MTD, tasks you want to do sooner<\/em> than 10 days you place in one of the two upper sections. Again, this rule is very simple, which is in keeping with the overall simplicity of the 1MTD system.<\/p>\n For example, in 1MTD, if a task is due in three weeks say, you would definitely put it in the Over-the-Horizon section, and that would get it out of sight for a while. You\u2019d review that section weekly, and when the date to do the task was inside ten days, you\u2019d promote that task back to the Critical Now or Opportunity Now sections, as appropriate. And in 1MTD, you might even put a due date on a task in the Over-the-Horizon zone to remind you to promote it on time.<\/p>\n A specific case of using the Over-the Horizon section in 1MTD might be a sales report that you need to write at the end of the month, but that you don\u2019t need to work on till then\u2014put that in the Over-the Horizon section and review that section weekly.<\/p>\n MYN\u2019s Use of the Over-the-Horizon zone <\/strong><\/p>\n In contrast, in the more powerful MYN system, you\u2019d place that same task in the Critical Now or Opportunity Now section\u2014with a future start date.<\/p>\n Why? Because in MYN, setting a future start date hides a task till that date, and that\u2019s useful for scheduling tasks you definitely intend to do. So unlike in 1MTD, in MYN any tasks you definitely intend to do would not<\/em> go into the Over-the-Horizon urgency zone\u2014that\u2019s the wrong place for them.<\/p>\n As a result, in MYN the Over-the-Horizon urgency zone is only used to list lower priority tasks, many of which may never get done. In essence, it is purely a review<\/em> zone. Things listed here only have a chance<\/em> of rising in priority on later review but often don\u2019t. The distinction from 1MTD is that in MYN you are never making a commitment to actually promote or do any items in your Over-the-Horizon list; you are just committing to consider<\/em> doing that on your next review.<\/p>\n An example might be a small optional project that just won\u2019t fit into your schedule and possibly never will. Or an old task that just isn\u2019t getting done and clearly does not out-bid your other tasks, but that you hope<\/em> to get to if you can. By the way, many items like this that I put in the Over-the-Horizon urgency zone in MYN sit there for weeks or months\u2014a few even for years\u2014and that\u2019s fine. And since most tasks drop in importance over time, I eventually delete nearly all of those.<\/p>\n You can do this too in 1MTD\u2019s Over-the-Horizon zone\u2014list long-term low-priority tasks like this. But in MYN that is the only<\/em> way you use the Over-the-Horizon urgency zone\u2014that\u2019s the difference. In MYN, long-term tasks you are committed to always go in the upper sections, hidden till the future. By the way, this MYN practice of setting the start date to the future date you intend to do them within the Critical Now or Opportunity Now zone, is called Defer-to-Do; you can read more about that in Lesson 9 of the Outlook book.<\/p>\n Another Example <\/strong><\/p>\n Another typical example demonstrating all these differences is this: let\u2019s say you must reach out to a client on Wednesday two weeks from now (at any time of the day) to remind him of an upcoming appointment the next day. So you put on your list \u201cCall Jim, reminder for Thursday meeting.\u201d Now here\u2019s the difference. In 1MTD you\u2019d list that in the Over-the-Horizon section with a deadline on it; when it got close you\u2019d then move it up. But in MYN you would initially list it in the Critical Now section and put a start date of the future Wednesday. That future date hides it, and then that Wednesday morning it will pop into the top of the Critical Now section, reminding you it must be done that day. So, as you can see there are subtle differences at play here.<\/p>\n Personally, I like the MYN approach better as it is more reliable and convenient. But 1MTD works well as long as you keep a good eye on your Over-the-Horizon zone and put some due dates on those tasks.<\/p>\n A Tradeoff<\/strong><\/p>\n Again, this more advanced use of the Over-the-Horizon zone in MYN is made possible by the use of the start date field, and is something you may want to consider when choosing between 1MTD and MYN. Because of this feature and others, MYN offers you the power to manage hundreds or even thousands of tasks (in contrast, 1MTD tops out at about 100 tasks). But proper use of the start date field in MYN can be subtle, can take a bit of thought, and usually takes a bit of initial software configuration effort\u2014all of which may lead you to want to stick with 1MTD for as long as you can.<\/p>\n","protected":false},"excerpt":{"rendered":" May 23, 2012 I often am asked to describe the differences between 1MTD and MYN. Most of you by now know that MYN is a more robust (and more complex) tasks system that handles higher volumes of tasks compared to … Continue reading